Bobcat S330 W4320 Error Code
W4320 Error Code
"Manbasket mode : Remote control not connected to Manbasket harness (from Receiver CAN Bus signal)" is the main cause of W4320 error.W4320 code needs proper lubrication of your transmission's moving parts, it's important to always drive with the right amount of clean fluid. It's good practice to periodically scan over the ground where your truck has been parked and check for signs of fluid leaks.
Tip For S330 Model
When an engine is running in an enclosed area, fresh
air must be added to avoid concentration of exhaust
fumes. If the engine is stationary, vent the exhaust
outside. Exhaust fumes contain odorless, invisible
gases which can kill without warning.
Do not engage the starter for longer than 15 seconds
at a time. Longer use can damage the starter by
overheating. Allow starter to cool for one minute
before using starter again.